Skip to main content

#6 단계의 변경 사항

Joe Frazier- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* icon_note] The clips disengaged in the next stepbullet may weaken and break after unclipping them.
[* icon_note] The clips disengaged in the next stepbullet may weaken and break after unclipping them.
[* black] Detach the screen from the logic board by using a spudger to unclip the four clips holding the screen (circled in Picture 1). Gently pull the screen away from the logic board so that none of the clips are engaged.
[* black] Remove the screen completely from the logic board by usingdisengaging the ribbon lock. Use a spudger to push back and up onthe thin black bar down (circled in Picture 2). Remove the screen from the ribbon cable lock to release itby gently pulling the screen away from the logic board.
[* black] Remove the screen completely from the logic board by usingdisengaging the ribbon lock. Use a spudger to push back and up onthe thin black bar down (circled in Picture 2). Remove the screen from the ribbon cable lock to release itby gently pulling the screen away from the logic board.

이미지 2

이전 버전

새로운 버전