메인 콘텐츠로 스킵하기

#6 단계의 변경 사항

Joe Frazier- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* blue] While firmly holdingblack] Detach the screen from the logic board, useboard by using a metal spudger to unclip the four clips holding the screen on.
[* icon_note] The clips will not be reusable once removed.
[* black] Now gently
screen. Gently pull the screen slightly away from the logic board so that none of the clips are engaged on the boardengaged.
[* icon_note] The clips may weaken and break after unclipping them
.
[* black] Last, useRemove the screen completely from the logic board by using a metal spudger to push back the ribbon cable lock. Pushing back and up on the ribbon cable lock willto release it.
[* black] Install
the cablenew screen by following these steps in reverse order.
[* blue] While firmly holdingblack] Detach the screen from the logic board, useboard by using a metal spudger to unclip the four clips holding the screen on.
[* icon_note] The clips will not be reusable once removed.
[* black] Now gently
screen. Gently pull the screen slightly away from the logic board so that none of the clips are engaged on the boardengaged.
[* icon_note] The clips may weaken and break after unclipping them
.
[* black] Last, useRemove the screen completely from the logic board by using a metal spudger to push back the ribbon cable lock. Pushing back and up on the ribbon cable lock willto release it.
[* black] Install
the cablenew screen by following these steps in reverse order.