Skip to main content

#6 단계의 변경 사항

Joe Frazier- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* icon_note] The clips disengaged in the next bullet may weaken and break after unclipping them.
[* black] Detach the screen from the logic board by using a spudger to unclip the four clips holding the screen (circled in Picture 1). Gently pull the screen away from the logic board so that none of the clips are engaged.
[* black] Remove theThe screen completely fromis attached to the logic board by a metal ribbon. Remove the screen by disengaging the ribbon lock. Use a spudger to push the thin black bar down (circled in Picture 2). RemoveGently pull the screen from theand ribbon by gently pulling the screen away fromout of the logic board.
[* black] Remove theThe screen completely fromis attached to the logic board by a metal ribbon. Remove the screen by disengaging the ribbon lock. Use a spudger to push the thin black bar down (circled in Picture 2). RemoveGently pull the screen from theand ribbon by gently pulling the screen away fromout of the logic board.