#2단계의 변경 사항
편집자 Avionne Traylor-
편집 승인됨 완료자 Avionne Traylor
- 이전
- 이후
- 변경 사항 없음
단계 라인
| [* red] Remove the blue wire by gently pulling. | |
| [* orange] Disconnect the brown cable. This is done by gently pulling the black tab away from the white plastic. This will loosen the tension on the brown cable, allowing it to slide away from the tab gently. | |
| - | [* yellow] Remove the |
| + | [* yellow] Remove the four Phillips #1 screws connecting the circuit board to the optical drive assembly. |
| [* icon_note] The fourth screw is located behind the screwdriver in the third picture ***(highlighted in the green circle)***. |