주요 콘텐츠로 건너뛰기

#2단계의 변경 사항

Lawrence- 에 의해 수정

편집 승인됨 완료자 Geoff Wacker

이전
이후
변경 사항이 없습니다

단계 라인

[* yellow] Remove the blue wire by gently pulling.
+[* yellow] Disconnect the Brown cable. This is done by gently pulling the black tab away from the white plastic. This will loosen the tension on the brown cable allowing it to gently be slid away from the tab.
[* orange] Shown in the third picture, remove the 4 Phillips #1 screws connecting the circuit board to the optical drive assembly.
[* icon_note] The fourth screw is located behind the screwdriver in the third picture ***(highlighted in the orange circle)***.