#7단계의 변경 사항
편집자 Alex Diaz-Kokaisl-
편집 승인됨 완료자 Alex Diaz-Kokaisl
- 이전
- 이후
- 변경 사항 없음
단계 라인
| + | [title] Remove the front panel assembly |
|---|---|
| + | [* black] Remove the front panel assembly. |
| + | [* icon_note] Use an opening pick to cut away any residual adhesive that may still be connecting the front panel assembly to the frame. |
| + | [* red] If you experience "ghost" or "phantom" touch input issues with your new display, this can be resolved by adding a layer of very thin insulating tape, such as [product|IF145-113-2|Kapton (polyimide) tape|new_window=true], to the highlighted areas on the back of the panel. ***iFixit replacement digitizers come with the proper insulation and should not require the addition of any tape.*** |
| + | [* icon_note] Without the proper insulation, these areas of the digitizer can ground out against other components, causing touch input malfunction. |
| + | [* icon_note] The insulation is not visible to the naked eye, and is different from the foam dust barrier strips found on many iPads. |
| + | [* icon_reminder] During reassembly, before installing a display, remove any remaining adhesive from the iPad, and clean the glued areas with high concentration isopropyl alcohol (90% or greater) and a lint-free cloth. This helps prep the iPad for fresh adhesive and ensures that it will bond properly. |
| + | [* icon_reminder] Test your iPad's functions and install [product|IF419-005-1|pre-cut adhesive strips|new_window=true] to the back of the display using our [guide|118753|display adhesive application guide|new_window=true] before sealing it up. |
이미지 1
이전 이미지 없음
추가
이미지 2
이전 이미지 없음
추가
이미지 3
이전 이미지 없음
추가