#7단계의 변경 사항
단계 라인
| + | [title] Install replacement battery |
|---|---|
| + | [* black] Solder the replacement battery back in place. Note which end has the positive (closest to the shaving head), usually this can be identified by a small ridge/dip on the battery case (if not clearly marked) |
| + | [* black] Replacement battery must be of the same voltage, although the capacity my be larger if needed. |
| + | [* black] You may need to trim (using scissors) the solder tags on the battery to make them narrow enough to fit through the holes in the PCB / circuit board |
이미지 1
이전 이미지 없음
추가