주요 콘텐츠로 건너뛰기

이 단계의 변경 사항

Mario Pecoraro- 에 의해 수정

편집 거부됨 에 의해 Walter Galan

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* icon_caution] Before disconnecting the thermal sensor cable, take note of its orientation. It is extremely important to reinstall the connector in the current orientation so the fans will not run at full speed. If you have multiple pins on your replacement hard drive, putdrive.
[* icon_note] Remember for the reinstall. Put
the connector closest to the SATA connections and the dark wire ( on top ) closest to the PCB board. If you fan is spinning like a jet engine, chances are its this connector. Just flip it and this should fix it.
[* icon_caution] Before disconnecting the thermal sensor cable, take note of its orientation. It is extremely important to reinstall the connector in the current orientation so the fans will not run at full speed. If you have multiple pins on your replacement hard drive, putdrive.
[* icon_note] Remember for the reinstall. Put
the connector closest to the SATA connections and the dark wire ( on top ) closest to the PCB board. If you fan is spinning like a jet engine, chances are its this connector. Just flip it and this should fix it.
[* black] Disconnect the thermal sensor, SATA power, and SATA data cables by pulling their connectors away from the sockets on the hard drive.