주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

#4단계의 변경 사항

Nicolas Siemsen- 에 의해 수정

편집 승인됨 완료자 Nicolas Siemsen

이전
이후
변경 사항이 없습니다

단계 라인

[* blue] Inside your driver's door, you will not find an actuator. Instead, there is a master vacuum switch that controls the actuators in the other three doors. In this picture, it is shown with the two Phillips head screws that hold its bracket in place already removed.
[* black] When the solid yellow line that you have been testing under the hood enters the firewall, it continues on and passes through a rubber tube between the vehicle's body and the door.
[* yellow] Once inside the door, it connects to the center vacuum connector on the main vacuum switch.
[* black] The next step will include disconnecting vacuum lines from the switch. To make this easier, disconnect the switch from the door. To do this, remove the two Philips head screws holding the switch to the door. Set the metal bracket aside.
[* red] Pull the switch gently towards you until you can then slip off the linkage that connectorsconnects the switch to the lock mechanism.
[* red] Pull the switch gently towards you until you can then slip off the linkage that connectorsconnects the switch to the lock mechanism.