메인 콘텐츠로 스킵하기

이 단계의 변경 사항

Andrew Optimus Goldheart- 에 의해 수정

편집 승인됨 에 의해 Andrew Optimus Goldheart

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Insert wisdom hereRemove the following screws securing the logic board to the rear case:
[* red] Two 2.3 mm Phillips screws
[* orange] Three 2.7 mm standoff screws
[* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver.
[* icon_reminder] Reassembly hint: when putting the standoffs back in, use the tip of a spudger like a screwdriver to get them started
.
[* black] Insert wisdom hereRemove the following screws securing the logic board to the rear case:
[* red] Two 2.3 mm Phillips screws
[* orange] Three 2.7 mm standoff screws
[* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver.
[* icon_reminder] Reassembly hint: when putting the standoffs back in, use the tip of a spudger like a screwdriver to get them started
.

이미지 1

이전 버전

새로운 버전