기기를 수리하세요

수리할 권리

상점

#8단계의 변경 사항

Andrew Optimus Goldheart- 에 의해 수정

편집 승인됨 완료자 Andrew Optimus Goldheart

이전
이후
변경 사항이 없습니다

단계 라인

[* black] Insert wisdom here.Remove the following screws securing the logic board to the rear case:
[* red] Two 2.3 mm Phillips screws
[* orange] Three 2.7 mm standoff screws
[* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver.
[* icon_reminder] Reassembly hint: when putting the standoffs back in, use the tip of a spudger like a screwdriver to get them started.
[* yellow] One 2.5 mm Phillips #000 screw
[* black] Insert wisdom here.Remove the following screws securing the logic board to the rear case:
[* red] Two 2.3 mm Phillips screws
[* orange] Three 2.7 mm standoff screws
[* icon_note] These screws have a Phillips bit pattern, but we found the best removal tool to be a 2.5 mm flathead driver.
[* icon_reminder] Reassembly hint: when putting the standoffs back in, use the tip of a spudger like a screwdriver to get them started.
[* yellow] One 2.5 mm Phillips #000 screw

이미지 1

이전 버전

새로운 버전