#13단계의 변경 사항
단계 라인
| [* black] Add 2 lengths of shrink-tube on the 2 wires |
| [* black] Now, solder the 4 wires together |
| [* icon_caution] Make sure to connect white to white, and black to the bear metalled one |
| [* icon_note] Make sure to do this step really quickly, as the heat-shrink tube will contract from the heat of the soldering |
| [* black] Alternatively, you could just use duct tape - just be careful it doesn't slide off when you're bending the wires |
| [* black] Move the shirk-tube over the soldering spots, and heat it up (mine fell a bit short, so I did end up using a bit of duct tape) |
이미지 1
이전 이미지 없음
추가
이미지 2
이전 이미지 없음
추가
이미지 3
이전 이미지 없음
추가