#3단계의 변경 사항
편집자 Daniel Slusser-
편집 승인됨 완료자 Daniel Slusser
- 이전
- 이후
- 변경 사항 없음
단계 라인
| + | [* black] Torque the bearing preload adjustment bolt on your stem cap just enough so that the knocking goes away. |
|---|---|
| + | [* black] Torque required is usually in the 2-3nm range. |
| + | [* black] If the steering feels rough or sluggish after tightening down the headset bearing preload bolt when turning your handlebars from side to side, you’ve over-tightened the headset. |
| + | [* black] Back it off an eighth or a quarter of a turn and check it again by turning the handlebars from side to side and pulling the front brake and rocking the handlebars front to back to feel for any knocking. |
이미지 1
이전 이미지 없음
추가
이미지 2
이전 이미지 없음
추가