주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

#1단계의 변경 사항

Adriana Rahrig- 에 의해 수정

편집 승인됨 완료자 Geoff Wacker

이전
이후
변경 사항이 없습니다

단계 라인

[*title] Remove the hard drive
[* icon_reminder] HDD is an abbreviation for "hard disk drive."
[*
icon_note] Before removing the HDD, you need to remove the temperature sensor attached to it and keep it for installationthat is mounted directly on the new HDD.
[* red]
hard drive. The HDD temperature sensor is mounted directly onattached to the hard drive,drive using adhesive tape and a protective foam cushion.
[* black] Carefully peel

[* red] Peel
off the foam and set the sensor aside. Be gentle with the foam, sincefoam because you will need to reuse it to connect the heat sensor to the new HDD.
[* blue] Lift the HDD out carefully,of the device and disconnect the two SATA cables from the drive.
[* icon_note] Replace the heat sensor in about the same position on your new
HDD. Make sure the flat surface of the sensor is flat against the metal hard drive enclosure, and add some adhesive tape to the foam (if necessary) to keep it in place.
[*title] Remove the hard drive
[* icon_reminder] HDD is an abbreviation for "hard disk drive."
[*
icon_note] Before removing the HDD, you need to remove the temperature sensor attached to it and keep it for installationthat is mounted directly on the new HDD.
[* red]
hard drive. The HDD temperature sensor is mounted directly onattached to the hard drive,drive using adhesive tape and a protective foam cushion.
[* black] Carefully peel

[* red] Peel
off the foam and set the sensor aside. Be gentle with the foam, sincefoam because you will need to reuse it to connect the heat sensor to the new HDD.
[* blue] Lift the HDD out carefully,of the device and disconnect the two SATA cables from the drive.
[* icon_note] Replace the heat sensor in about the same position on your new
HDD. Make sure the flat surface of the sensor is flat against the metal hard drive enclosure, and add some adhesive tape to the foam (if necessary) to keep it in place.