주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

#2단계의 변경 사항

Adriana Rahrig- 에 의해 수정

편집 승인됨 완료자 Geoff Wacker

이전
이후
변경 사항이 없습니다

단계 라인

[title] ReplacingReplace the hard drive.drive
[* red] Using a Phillips #00 screwdriver, remove the four metal spacers (pegs) from the old HDD and install them in the same placeslocations on yourthe new HDD.
[*

[*
icon_note] If the new HDD is thinner than the old oneHDD, you may need to unscrew the spacers a few turns to preventprevent the driveHDD from rattling aroundaround in the device.
[* black] Place the temperature sensor in approximately the same position on the new HDD as on the old HDD. Cover the sensor with the foam, using adhesive tape if necessary.
[* icon_reminder] Make sure the surface of the sensor is flat against the metal hard drive enclosure
.
[* icon_note] To save power and reduce waste heatheat waste, use a "green" (power-saving) hard drive or a low-speed (5400 RPM) hard drive.
[* icon_reminder] Be sure to format your new HDD using the Airport Utility when you are done and the Time Capsule is reassembled. You might have to hard reset the Time Capsule after installation.
[* icon_caution
icon_note] It is possible to test run the unitdevice's functionality before it is fully reassembled. If youreassembling it. To do so, reconnect the fan and replace the metal shield / fan assemblycasing (without installing the screws) before turning it on toscrews).
[* icon_caution] To
prevent electrical shock and overheatingoverheating, complete this step before turning the device on.
[* icon_reminder] After the Time Capsule is reassembled, format the new HDD using Airport Utility. It may be necessary to perform a hard reset on the Time Capsule
.
[title] ReplacingReplace the hard drive.drive
[* red] Using a Phillips #00 screwdriver, remove the four metal spacers (pegs) from the old HDD and install them in the same placeslocations on yourthe new HDD.
[*

[*
icon_note] If the new HDD is thinner than the old oneHDD, you may need to unscrew the spacers a few turns to preventprevent the driveHDD from rattling aroundaround in the device.
[* black] Place the temperature sensor in approximately the same position on the new HDD as on the old HDD. Cover the sensor with the foam, using adhesive tape if necessary.
[* icon_reminder] Make sure the surface of the sensor is flat against the metal hard drive enclosure
.
[* icon_note] To save power and reduce waste heatheat waste, use a "green" (power-saving) hard drive or a low-speed (5400 RPM) hard drive.
[* icon_reminder] Be sure to format your new HDD using the Airport Utility when you are done and the Time Capsule is reassembled. You might have to hard reset the Time Capsule after installation.
[* icon_caution
icon_note] It is possible to test run the unitdevice's functionality before it is fully reassembled. If youreassembling it. To do so, reconnect the fan and replace the metal shield / fan assemblycasing (without installing the screws) before turning it on toscrews).
[* icon_caution] To
prevent electrical shock and overheatingoverheating, complete this step before turning the device on.
[* icon_reminder] After the Time Capsule is reassembled, format the new HDD using Airport Utility. It may be necessary to perform a hard reset on the Time Capsule
.