주요 콘텐츠로 건너뛰기

#1 단계의 변경 사항

Richdave- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] The LCD sensor is located on the rear of the display panel in the top right corner when viewed from the rear. It is under the black foil about 40mm from the top edge of the panel.
[* black] Carefully cut the foil on an angle from the corner and peel it back to expose the sensor. It will have a foam pad stuck over it.
[* black] Gently peel the foam off the sensor to reveal the PCB assembly.
[* icon_caution] The Sensor is held in place with a small adhesive pad so to remove it, gently pry it up from one edge with a plastic spudger or similar. I recommend NOT using metal tools here.
[* black] If you need to replace the cable, gently lift the right edge of the black PSU guard and carefully peel the cable off the adhesive backing on the guard.