주요 콘텐츠로 건너뛰기

#3 단계의 변경 사항

Bill Otto- 에 의해 수정

편집 승인됨 에 의해 Andrew Optimus Goldheart

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Use the clear plastic pull tab to gently lift the battery out of the iPhone.
[* black] Be careful when removing the battery with the plastic pull tab. On some units, Apple uses an excessive amount of glue, making it virtually impossible to remove the battery in this fashion (with the tab possibly tearing due to excessive force).
[* black] For batteries that "stick", you could use the iPod opening tool to assist (take extra care whilst doing so).
[* black] You might find it easier to pry the prybattery out from the right-hand side as there wasbecause no glue is used on this sideside.
[* black] You might find it easier to pry the prybattery out from the right-hand side as there wasbecause no glue is used on this sideside.
[* black] Remove the battery.
[* icon_note] Before reconnecting the battery connector, be sure the pressure contact (shown in red) is properly positioned next to the battery connector.
[* icon_caution] Before reassembly, be sure to clean all metal-to-metal contact points on the pressure contact as well as its contact point on the rear panel with a de-greaser such as windex (96% ethanol alcohol works well too, but make sure that contacts are dry when done). The oils on your fingers have the potential to cause wireless interference issues.