메인 콘텐츠로 스킵하기

#7 단계의 변경 사항

scbr- 에 의해 수정

편집 거부됨 에 의해 Jake Devincenzi

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Remove the following five screws securing the wi-fi antenna to to the logic board:
[* red] One 2.3 mm Phillips
[* orange] Two 1.6 mm Phillips
[* yellow] One 1.4 mm Phillips
[* green] One 4.8 mm Phillips
[* icon_caution] When'''''When re-assembling, start off with replacing the 4.8 mm Philips screw first, then the 2.3 mm. ''This is to ensure there is no mix-up, and avoid renderingBREAKING the LCD and digitizer useless.useless.'''''''
[* icon_caution] When'''''When re-assembling, start off with replacing the 4.8 mm Philips screw first, then the 2.3 mm. ''This is to ensure there is no mix-up, and avoid renderingBREAKING the LCD and digitizer useless.useless.'''''''
[* icon_caution] Also make sure to put the long 4.8 mm Philips back in correctly when reassembling. This is the ground for the Wi-Fi antenna and is often the culprit if you are having bad wi-fi reception after reassembly.