#2단계의 변경 사항
편집자 Dominick Giguere-
편집 승인됨 완료자 Dominick Giguere
- 이전
- 이후
- 변경 사항 없음
단계 라인
| - | [title] |
|---|---|
| + | [title] Hot Melt Glue |
| [* black] Follow the wires to find where they connect to the printed circuit board (PCB). At the area of connect, two spots will be marked "DC+ and "DC-." | |
| - | [* black] Apply rubbing alcohol to cotton swab end. Rub end on hot melt glue and wait 30 seconds, then apply alcohol to hot melt glue again. |
| - | [* black] Use tweezers to grab softened hot melt glue. Pull hot melt glue off of clock radio. |
| + | [* black] Apply the rubbing alcohol to a cotton swab end. Rub the end on the hot melt glue and wait 30 seconds, then apply the alcohol to the hot melt glue again. |
| + | [* black] Use tweezers to grab the softened hot melt glue. Pull the hot melt glue off of the clock radio. |