메인 콘텐츠로 스킵하기

#9 단계의 변경 사항

Eric Essen- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Turn your car on and let it warm up for about 5-10 minutes.
[* red] There is a bleeder valve that allows air to escape so not to be trapped in a high spot in our cooling system above the tubethermostat. Loosing this slightly will allow the air to expose the small escape hole on the sidebleed out of it.
[* black] As
the car warms up, the engine will start needing the coolant sosystem. You can re-close it will begin to circulate. Asas soon as you see small amount of coolant coming out of the hole, you can screw it down.
[* black] Put the radiator cap back on and turn off your car allowing it to cool off
leaking from it.
[* red] There is a bleeder valve that allows air to escape so not to be trapped in a high spot in our cooling system above the tubethermostat. Loosing this slightly will allow the air to expose the small escape hole on the sidebleed out of it.
[* black] As
the car warms up, the engine will start needing the coolant sosystem. You can re-close it will begin to circulate. Asas soon as you see small amount of coolant coming out of the hole, you can screw it down.
[* black] Put the radiator cap back on and turn off your car allowing it to cool off
leaking from it.
[* black] After it is cool, top off the coolant again by filling up the radiator and turn the car back on.
[* black] You can also at this point top off the coolant reservoir.
[* black] You are done!