메인 콘텐츠로 스킵하기

#9 단계의 변경 사항

Eric Essen- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Turn your car on and let it warm up for about 5-10 minutes. You want to wait until your thermostat opens, and allows coolant to circulate through your system.
[* red] There is a bleeder valve that allows air to escape so not to be trapped in a high spot in ourthe cooling system above the thermostat. Loosing this slightly will allow the air to bleed out of the system. You can re-close it as soon as you see coolant leaking from it.
[* black] After it is cool, top off the coolant again by filling up the radiator and turnchecking the car back oncoolant reservoir.
[* black] Youicon_caution] Never open the radiator cap while the engine is hot. Pressurized steam can also at this point top off the coolant reservoircause serious injury.
[* black] Turn your car on and let it warm up for about 5-10 minutes. You want to wait until your thermostat opens, and allows coolant to circulate through your system.
[* red] There is a bleeder valve that allows air to escape so not to be trapped in a high spot in ourthe cooling system above the thermostat. Loosing this slightly will allow the air to bleed out of the system. You can re-close it as soon as you see coolant leaking from it.
[* black] After it is cool, top off the coolant again by filling up the radiator and turnchecking the car back oncoolant reservoir.
[* black] Youicon_caution] Never open the radiator cap while the engine is hot. Pressurized steam can also at this point top off the coolant reservoircause serious injury.
[* black] You are done!