주요 콘텐츠로 건너뛰기

#2단계의 변경 사항

Oh Tee- 에 의해 수정

편집 승인됨 완료자 Oh Tee

이전
이후
변경 사항이 없습니다

단계 라인

-[* black] Remove screws around the edge of the tablet.
+[* icon_caution] Two screws hold the power connector in place. Remove these before trying to remove anything else.
[* black] Four screws and one cable will remove the speaker assembly.
[* black] Three screws and a pop on connector secure the micro-SD reader.
[* black] There are several screws that hold the battery tray in place. The battery is held in with fairly strong adhesive, so I didn't try to take it out of the tray.
[* black] Three cables are attached to the touch board. I didn't try to remove this board from the frame.
-[* icon_caution] Two screws hold the power connector in place. Remove these before trying to remove anything else.
[* black] Disconnect the four cable connectors that lay across the battery. The cables with blue tabs do not have a locking mechanism holding the cable in place.
[* black] There are two magnets located at the bottom center. More than likely used for a case cover or for a feature not included on this tablet.

이미지 1

이전 이미지 없음

추가