이 단계의 변경 사항
편집자 Tyler Parra-
- 이전
- 이후
- 변경 사항 없음
단계 라인
[* black] To make sure your brake pads are seated properly when the break levers are pulled, you will need the brake pads loose enough to move them by hand but tight enough so they don't move after you adjust them. | |
[* black] Fold a piece of paper 2-3 times and slip it under the side of the brake pad that contacts the rim first when the wheel is rotating. This will stop squeaky brakes. | |
[* black] With the paper still in between the rim and pad, lightly pull the brake lever. | |
- | [* black] Position the brake pad so it is not |
+ | [* black] Position the brake pad so it is not in contact with the rubber tire. Angle the pad so it sits flat on the rim. |
[* black] With the brake pad in its correct position, pull the brake lever as hard as you can while tightening the nut on the brake pad. Check to see if the pad is still not rubbing on the tire and is still flat on the rim. | |
[* black] Repeat for the brake pad on the other side. |