Skip to main content

#4 단계의 변경 사항

Mark Warren- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Next, we turn to the underside of the quadricopter.
[* black] After removing four T6 Torx screws, the lower plate can be lifted off to reveal the motherboard and navigation board.
[* black] The navigation board is connected to the motherboard by eight pins and comes out without any hassle.
[* black] NOTE: The ribbon cable must be removed with EXTREME care otherwise it will tear. If you look at the connector there is a black section where the cable connects, you need to gently pull this black portion, and you should then be able to easily remove the cable.