주요 콘텐츠로 건너뛰기

#3단계의 변경 사항

Jeff Suovanen- 에 의해 수정

편집 승인됨 완료자 Jeff Suovanen

이전
이후
변경 사항이 없습니다

단계 라인

-[* icon_note] The bracket that contains the display and digitizer cable connections is made up of an upper and lower piece. The connectors are secured to the lower, and the upper must be removed to disconnect them.
-[* black] Use fine-tipped tweezers to grasp the lower half of the bracket.
-[* icon_note] There is a small metal tab that protrudes downward from the upper metal bracket.
-[* black] Insert a small (1 mm) flathead screwdriver between the tab and the lower bracket, and rotate the screwdriver to spread the gap.
-[* black] This will release two tabs that hold the upper bracket to the lower, and should free the upper bracket.
+[* black] Steady the bracket from the left side using your fingers or tweezers.
+[* black] At the same time, insert a small (1 mm) flathead screwdriver under the tiny tab on the right.
+[* black] Finally, place one finger behind the tab, and pinch the bracket ''hard'' between your finger and the screwdriver to detach the cover.
+ [* icon_note] This releases two slotted tabs that hold the cover to the bracket, and should free the cover.
+ [* icon_caution] Prying the cover off can be challenging and may take more than one attempt. Be patient, and take care not to pull on the bracket or tear the attached cables.

이미지 1

이전 버전

새로운 버전

이미지 2

이전 버전

새로운 버전

이미지 3

이전 버전

새로운 버전