주요 콘텐츠로 건너뛰기

#26단계의 변경 사항

Scott Havard- 에 의해 수정

편집 승인됨 완료자 Scott Havard

삭제됨
추가
변경 사항이 없습니다

단계 라인

[* black] Slide a plastic card underneath the center of the motherboardlogic board, pushing it in as far as it will go.
[* black] Slowly swing the left edge of the motherboardlogic board up, while making sure it doesn't snag against any of the disconnected cables.
[* icon_caution] If any portion of the motherboardlogic board requires excessive force to pry up, stop prying, re-apply the iOpener, and re-perform the corresponding guide steps to fully release the adhesive.
[* black] Slide a plastic card underneath the center of the motherboardlogic board, pushing it in as far as it will go.
[* black] Slowly swing the left edge of the motherboardlogic board up, while making sure it doesn't snag against any of the disconnected cables.
[* icon_caution] If any portion of the motherboardlogic board requires excessive force to pry up, stop prying, re-apply the iOpener, and re-perform the corresponding guide steps to fully release the adhesive.