Andis Master Clippers Motor/Coil Assembly Replacement 단계 #4 기록

#4단계의 변경 사항

편집자 Marcus Thomas- 2015년 10월 2일

편집 승인됨 완료자 Marcus Thomas

-	[* black] Locate the Motor Core and follow it's power wires to the Attached power cord.
-	[* icon_caution] Black being {Negative} goes with the Black wire, Red being {Positive} goes with white cord connected to the Attached power cord.
-	[* black] Next: unravel the {Positive,Negative} wire from the motor that connects to the wire attached cord.
-	[* black] Strip the ends of each wire with the wire strippers approximately 1-2cm down to reveal enough wire to twist back together with new motor's wires .
-	[* icon_reminder] Be sure to keep track of the corresponding wires and their locations to match when the new motor is inserted.
+	[* yellow] Next, using the wire cutters, cut the {Positive & Negative} wires, leading from the *Coil Assembly* to the *Attached power cord*, approximately half way between the two ends of both wires.
+	[* icon_note] Note: Black being {Negative} goes with the Black wire, Red being {Positive} goes red, but in this case, with the white cord (all depending on how the manufacturer ships it) extending from the *Attached power cord*.
+	[* red] Strip the ends of each wire with the wire strippers approximately 1-2cm down to reveal enough wire to twist back together with new motor's wires .
+	[* icon_reminder] Reminder: Be sure to keep track of the corresponding wires and their locations to match when the new motor is inserted.