#11단계의 변경 사항
단계 라인
| + | [title] Cable up new fan |
|---|---|
| + | [* black] Drill two holes above where fan will end up, so that the splices can be tucked between "floor" of cube and circuit board. |
| + | [* black] You will run the cable supplying power to fan through one hole in deck, and the cable from the fan itself through the other, then splice them red-to-(marked-red) and black-to-(marked-black.) |
| + | [* black] Note after-shot, showing finished splices, and position of cable leading to 3-way switch around corner. |
이미지 1
이전 이미지 없음
추가
이미지 2
이전 이미지 없음
추가
이미지 3
이전 이미지 없음
추가