물건을 수리하세요 커뮤니티 상점

#16단계의 변경 사항

편집자 Netmammal-

편집 승인됨 완료자 Netmammal

이전
이후
변경 사항 없음

단계 라인

[title] Test again?
[* black] If you have not tested the fan yet, it is recommended that you attach the connector to the fan header on the circuit board, put water in the tank, temporarily re-attach the connector for the ribbon cable to the control panel.
[* black] You will have to have the cube right-side up so that the float switch lets the unit know that there is water in the reservoir, which means that it will be sitting on top of those open circuit boards.
-[* black] Just be careful about putting your hand near that power supply when you have this plugged in!
-[* black] ...And if you have been resting this on a cookie sheet, find a towel or something else non-conductive so that it is not resting on metal, before you plug it in.
+[* icon_caution] Just be careful about putting your hand near that power supply when you have this plugged in!
+[* icon_caution] ...And if you have been resting this on a cookie sheet, find a towel or something else non-conductive so that it is not resting on metal, before you plug it in.
[* black] Having done all of that, when you plug it in, and turn it on using the control panel on the top, the fans should spin.