주요 콘텐츠로 건너뛰기

#11단계의 변경 사항

David Mitchell- 에 의해 수정

승인 대기 중

삭제됨
추가
변경 사항이 없습니다

단계 라인

[* black] Remove the following 8 screws:screws and organize them on the tape on your bench.
[* black] Remove the following 8 screws:screws and organize them on the tape on your bench.
[* red] Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear panel.
[* orange] Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.
[* yellow] One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.
[* black] Note for re-assembly:
[* black] The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place. The strap fits into a slot on the camera.
[* black] The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place. The strap fits into a slot on the camera.
[* black] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screws with full thread next to the camera