#11단계의 변경 사항
Alberto- 에 의해 수정
편집 승인됨 완료자 Scott Havard
- 삭제됨
- 추가
- 변경 사항이 없습니다
단계 라인
[* black] Remove the following 8 screws: |
[* red] Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case. |
[* orange] Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera. |
[* yellow] One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker. |
[* black] Note for re-assembly: |
[* black] The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place. |
[* icon_reminder] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 |
[* icon_reminder] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 |