Skip to main content

#13 단계의 변경 사항

blend- 에 의해 수정

편집 거부됨 에 의해 Brett Hartt

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Use a spudger to disconnect the ribbon cable labeled "4."
[* black] Use a spudger to gently pry up the end of the logic board closest to the dock connector.
[* icon_caution] There is a small golden grounding tab on logic board adjacent to the 'do not remove sticker'. Be VERY careful this does not snag on the side of the case when prying up the logic board; it breaks easily. If you have signal problems after removing the logic board, check this ground tab.
[* icon_note] If the board won't lift up, double check to make sure all the screws securing the logic board have been removed.