메인 컨텐츠로 가기

#1 단계의 변경 사항

Andrew Bookholt- 에 의해 수정

승인 대기 중

삭제되었습니다
추가되었습니다
변경 사항 없음

스텝 라인

[* icon_caution] The next few steps bring your hands close to the exposed face of the power supply. To avoid a high voltage shock from the many large capacitors attached to the board, do not touch the face of the power supply.
[* black] Remove the following four screws securing the power supply to the outer case:
[* icon_caution] The next few steps bring your hands close to the exposed face of the power supply. To avoid a high voltage shock from the many large capacitors attached to the board, do not touch the face of the power supply. [* red] One 9.3 mm T10 coarse-threaded screw
[* orange] One 25 mm T10 coarse-threaded screw
[* yellow] Two 22 mm fine-threaded screws
[* icon_caution] The next few steps bring your hands close to the exposed face of the power supply. To avoid a high voltage shock from the many large capacitors attached to the board, do not touch the face of the power supply. [* red] One 9.3 mm T10 coarse-threaded screw
[* orange] One 25 mm T10 coarse-threaded screw
[* yellow] Two 22 mm fine-threaded screws

이미지 1

이전 버전

새로운 버전

이미지 2

삭제되었습니다