#6단계의 변경 사항
Andrew Bookholt- 에 의해 수정
- 이전
- 이후
- 변경 사항이 없습니다
단계 라인
| [* red] Insert a 1.2 mm Phillips screw into each of the outer holes drilled into the trackpad (two screws total). |
| [* red] Insert a 1.2 mm Phillips screw into each of the outer holes drilled into the trackpad (two screws total). |
| [* icon_caution] You'll install the rest in a bit. |
| [* icon_note] When you tighten the two screws, make them tight and then back them out about a quarter turn to aid in aligning your trackpad during the next few steps. |