주요 콘텐츠로 건너뛰기

#4단계의 변경 사항

Jeff Suovanen- 에 의해 수정

편집 승인됨 완료자 Jeff Suovanen

이전
이후
변경 사항이 없습니다

단계 라인

[* black] Place the leads of the resistor through the holes on either side of the rectangle marked ***R1*** on the circuit board.
[* icon_note] Resistors do not have to be installed in a particular orientation. Either lead can go into either hole.
-[* black] Turn the board over so that the copper traces are facing up and the resistor leads are pointing straight up in the air, as seen in the second picture
+[* black] Turn the board over so that the copper traces are facing up and the resistor leads are pointing straight up in the air, as seen in the second picture.
[* icon_note] You may also bend the leads outward to hold the resistor in place, but this is not necessary. As per NASA guidelines, any angle up to 30° down from vertical is acceptable.