주요 콘텐츠로 건너뛰기

#7단계의 변경 사항

Jake Devincenzi- 에 의해 수정

승인 대기 중

이전
이후
변경 사항이 없습니다

단계 라인

[* black] Use the same method above to solder the second resistor lead to the circuit board.
-[* black] Cut the extra length of resistor lead with a pair of cutting pliers. NASA workmanship standards state that any length up to 2.29 mm is acceptable.
+ [* icon_note] After soldering a joint, if you are going to put the soldering iron down, be sure to place it back in its stand to prevent burning yourself or anything around you.
+[* black] Cut the extra length of resistor lead with a pair of wire cutters. NASA workmanship standards state that any length up to 2.29 mm is acceptable.