#1단계의 변경 사항
편집자 Sean Croft-
편집 승인됨 완료자 Sean Croft
- 이전
- 이후
- 변경 사항 없음
단계 라인
| + | [* black] Using your tweezers, undo all ribbon cable you see where the keyboard was removed. |
|---|---|
| + | [* black] Remove all screws from the rear panel of your computer. They are marked in the first picture. |
| + | [* black] Using your fingers, push the bottom of the battery compartment out slightly, making a small gab in the face plate on the opposite side. |
| + | [* black] Using the spudger, undo all clips around the outer edge of the computer, popping the front face plate out of the enclosure. If you meet resistance, you most likely forgot to remove a screw, check for any that are still there, and remove them. |
| + | [* black] Once the front plate has been popped out, look close to make sure all connections are disconnected from it before pulling it away from the computer. |
이미지 1
이전 이미지 없음
추가
이미지 2
이전 이미지 없음
추가
이미지 3
이전 이미지 없음
추가