주요 콘텐츠로 건너뛰기

#7 단계의 변경 사항

oldturkey03- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] You should now be looking at the PCB's The power board is the one that has the switch on it, as well as two heatsinks.
[* black] Remove the wiring harness on the top right side.
[* black] Remove the connector from the inverter board, as well as the ground wire.
[* black] Remove the green cable from the power board to the housing.
[* black] Remove the connector from the top right and top side. They will only fit one way. No reason to mark the location.
[* black] Remove theThe two heatsinks can be removed either now or later. It does not matter but is personal preference.
[* black] Remove theThe two heatsinks can be removed either now or later. It does not matter but is personal preference.