주요 콘텐츠로 건너뛰기

#7 단계의 변경 사항

Jasper Fleischhauer- 에 의해 수정

편집 승인됨 에 의해 Jasper Fleischhauer

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Disconnect the trackpad and keyboard ribbon cable from the logic board, removing tape as necessary.
[* icon_note] Note: It is possible to replace the hard drive without disconnecting the keyboard from the chassis, but it will need to be held upright to keep it out of the way, while still allowing you both hands to work on the drive removal.
[* icon_note]
Be careful when removing the keyboard-trackpad ribbon cable to ensure that the rear of the upper case is disengaged from the area near the hinge. It is easy to accidentally bend the screw receivers on either side of the keyboard.
[*

[*
black] Remove the upper case.
[* icon_note] Note: It is possible to replace the hard drive without disconnecting the keyboard from the chassis, but it will need to be held upright to keep it out of the way, while still allowing you both hands to work on the drive removal.
[* icon_note]
Be careful when removing the keyboard-trackpad ribbon cable to ensure that the rear of the upper case is disengaged from the area near the hinge. It is easy to accidentally bend the screw receivers on either side of the keyboard.
[*

[*
black] Remove the upper case.