주요 콘텐츠로 건너뛰기

#9단계의 변경 사항

Rene Jeddore- 에 의해 수정

편집 승인됨 완료자 Rene Jeddore

이전
이후
변경 사항이 없습니다

단계 라인

[title] Remove ribbon cablecables from board and yaw arm
[title] Remove ribbon cablecables from board and yaw arm
[* black] Next you need to peel the ribbon cable off of the yaw arm. It is sticky, but not too bad. I would recommend using a hair dryer to warm it if possible to soften the adhesive.
[* black] Carefully peel it off the yaw arm.
[* black] Remove the brown ribbon cable from the circuit board first. This is another zif slot with a tab the needs to be lifted with your fingernail.
[* black] after the brown cable is removed it is easier to remove the black ribbon cable.
[* black] Set the circuit board aside.