#1단계의 변경 사항
편집자 Scott Head-
- 이전
- 이후
- 변경 사항 없음
단계 라인
| + | [* black] Remove the following five screws securing the wi-fi antenna to to the logic board: |
|---|---|
| + | [* red] One 2.3 mm Phillips |
| + | [* orange] Two 1.6 mm Phillips |
| + | [* yellow] One 1.4 mm Phillips |
| + | [* green] One 4.8 mm Phillips |
| + | [* icon_caution] When re-assembling, start off with replacing the 4.8 mm Philips screw first, then the 2.3 mm. This is to ensure there is no mix-up, and avoid rendering the LCD and digitizer useless. |
| + | [* icon_caution] Also make to to put the long 4.8 mm Philips back in correctly when reassembling. This is the ground for the wi-fi antenna and is often the culprit of you are having bad wi-fi reception after reassembly. |
이미지 1
이전 이미지 없음
추가