메인 컨텐츠로 가기

#3 단계의 변경 사항

John Schutz- 에 의해 수정

편집 거부됨 에 의해 Geoff Wacker

삭제되었습니다
추가되었습니다
변경 사항 없음

스텝 라인

[* black] Use a plastic opening tool to pullgently detach the pressure contactbattery connector from underneath the battery connector.
[* icon_caution] When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils
socket on your fingers have the potential to create wireless interference.
[* icon_caution] Take notice of
device. Start lifting off the position ofconnector from the small black ground clip onbottom side, by placing the upper screwtip of the battery connector. This clip is attached only bytool between the upper screw. When reinstalling, it must be aligned soloudspeaker enclosure and the gold contact point will press againstmetal cover of the back coverconnector.
[* blackicon_note] The battery connector comes off vertically from the logic board. Do not apply force sideways.
[* icon_caution
] Be careful not to rip off the battery connector socket soldered on the logic board. There are 4 very small soldering points awaiting this mistake!
[* black] Use a plastic opening tool to pullgently detach the pressure contactbattery connector from underneath the battery connector.
[* icon_caution] When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils
socket on your fingers have the potential to create wireless interference.
[* icon_caution] Take notice of
device. Start lifting off the position ofconnector from the small black ground clip onbottom side, by placing the upper screwtip of the battery connector. This clip is attached only bytool between the upper screw. When reinstalling, it must be aligned soloudspeaker enclosure and the gold contact point will press againstmetal cover of the back coverconnector.
[* blackicon_note] The battery connector comes off vertically from the logic board. Do not apply force sideways.
[* icon_caution
] Be careful not to rip off the battery connector socket soldered on the logic board. There are 4 very small soldering points awaiting this mistake!

이미지 1

이전 버전

새로운 버전

이미지 2

이전 버전

새로운 버전

이미지 3

삭제되었습니다