Skip to main content

#3 단계의 변경 사항

John Schutz- 에 의해 수정

편집 승인됨 에 의해 Andrew Optimus Goldheart

삭제되었습니다
추가되었습니다
변경 사항 없음

스텝 라인

[* black] Use a plastic opening tool to pull the pressure contact from underneath the battery connector.
[* icon_caution] When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils on your fingers have the potential to create wireless interference.
[* icon_caution] Take notice of the position of the small black ground clip on the upper screw of the battery connector. This clip is attached only by the upper screw. When reinstalling, it must be aligned so the gold contact point will press against the back cover.
[* black] Be '''VERY''' careful not to removerip off the pressure contact point frombattery connector socket soldered on the logic board. There are 4 very small soldering points awaiting this mistake!
[* black] Be '''VERY''' careful not to removerip off the pressure contact point frombattery connector socket soldered on the logic board. There are 4 very small soldering points awaiting this mistake!