주요 콘텐츠로 건너뛰기

#6 단계의 변경 사항

Yves- 에 의해 수정

편집 거부됨 에 의해 Taylor Dixon

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] If present, peel the piece of black tape covering the hidden screw near the power button.
[* red] Remove the 2.6 mm Phillips screw securing the logic board near the power button. This screw is not visible in the red square are of the picture.
[* red] Remove the 2.6 mm Phillips screw securing the logic board near the power button. This screw is not visible in the red square are of the picture.
[* icon_caution] (Use caution when removing this screw and removing the power contact held by it; the contact tab will come loose with the screw)
[* icon_note] Notice the small rubber bumper under the screen & digitizer cables (which are detached at top above the Q-code). This bumper can fall off of the logic board when removed or get stuck to the cables and fall off later.