주요 콘텐츠로 건너뛰기

#7 단계의 변경 사항

Walter Galan- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* red] Removeblack] Remove the 3.4following screws securing the logic board to the case:
[* red] One 2.5
mm Phillips screw near the vibrator motor.
[*
motor
[*
orange] Use a small flathead screwdriver to remove the twoOne 2.4 mm Phillips screw
[* yellow] One
3.6 mm standoffsstandoff along the side of the logic board nearest the battery opening.
[* icon_note] Use a small flathead screwdriver to remove the single 3.6 mm standoff.
[* red] Removeblack] Remove the 3.4following screws securing the logic board to the case:
[* red] One 2.5
mm Phillips screw near the vibrator motor.
[*
motor
[*
orange] Use a small flathead screwdriver to remove the twoOne 2.4 mm Phillips screw
[* yellow] One
3.6 mm standoffsstandoff along the side of the logic board nearest the battery opening.
[* icon_note] Use a small flathead screwdriver to remove the single 3.6 mm standoff.

이미지 1

이전 버전

새로운 버전