주요 콘텐츠로 건너뛰기

#7 단계의 변경 사항

Dominik Schnabelrauch- 에 의해 수정

편집 승인됨 에 의해 Dominik Schnabelrauch

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* black] Remove the following screws securing the logic board to the case:
[* red] One 2.5 mm Phillips screw near the vibrator motor
[* orange] One 2.4 mm Phillips screw
[* yellow] One 3.6 mm standoff along the side of the logic board nearest the battery opening.
[* icon_note] Use a [product|IF145-343|standoff driver bit|new_window=true] or a small flathead screwdriver toand [product|IF145-326|driver handle|new_window=true] to remove the single 3.6 mm standoff screw.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.
[* icon_note] Use a [product|IF145-343|standoff driver bit|new_window=true] or a small flathead screwdriver toand [product|IF145-326|driver handle|new_window=true] to remove the single 3.6 mm standoff screw.
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.