메인 콘텐츠로 스킵하기

#5 단계의 변경 사항

Andrew Bookholt- 에 의해 수정

승인 대기 중

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* icon_note] DisconnectingThe logic board is still connected to the front case by the following twodisplay ribbon cables may be challenging. To prevent strainingcable, located on the cables or connectors, you can only separateheadphone jack side of the two halveslogic board. When lifting the logic board out of the iPodfront case, do so as you would open a book by rotating the board about 1/2 inch during the processdisplay ribbon cable.
[* black] Use a spudger to slideLift the logic board from the click wheel connector side (the cable out of its connectoryou just disconnected) and lay the logic board next to the front case.
[* icon_note] DisconnectingThe logic board is still connected to the front case by the following twodisplay ribbon cables may be challenging. To prevent strainingcable, located on the cables or connectors, you can only separateheadphone jack side of the two halveslogic board. When lifting the logic board out of the iPodfront case, do so as you would open a book by rotating the board about 1/2 inch during the processdisplay ribbon cable.
[* black] Use a spudger to slideLift the logic board from the click wheel connector side (the cable out of its connectoryou just disconnected) and lay the logic board next to the front case.

이미지 1

이전 이미지가 없습니다

추가

이미지 2

이전 이미지가 없습니다

추가