주요 콘텐츠로 건너뛰기

기기를 고치세요

수리할 권리

부품 & 도구

#12단계의 변경 사항

BobJohnson- 에 의해 수정

편집 승인됨 완료자 BobJohnson

이전
이후
변경 사항이 없습니다

단계 라인

[* red] Remove the nut from the plate against the PCB, using a Phillips screwdriver.
[* icon_caution] The order of loosening the snap-fitssnapfits now becomesis important. First carefully press out (in an upward direction) four click fingers (of thefrom plastic buttons) that hold the plate in place, and then push out four pins in the PCB. This will loosenPCB (holes marked with black arrows), which loosens the buttons. Beware of not affecting the transistorstransistor integrity when removing the plate.
[* icon_caution] The order of loosening the snap-fitssnapfits now becomesis important. First carefully press out (in an upward direction) four click fingers (of thefrom plastic buttons) that hold the plate in place, and then push out four pins in the PCB. This will loosenPCB (holes marked with black arrows), which loosens the buttons. Beware of not affecting the transistorstransistor integrity when removing the plate.
[* blue] Remove the snap-fits of the PCB, so the plate and the PCB can be disconnected. Use a flathead screwdriver for punching and sculling.

이미지 2

이전 버전

새로운 버전

이미지 3

이전 버전

새로운 버전