주요 콘텐츠로 건너뛰기

기기를 수리하세요

수리할 권리

상점

#4단계의 변경 사항

Richard Suovanen- 에 의해 수정

편집 승인됨 완료자 Richard Suovanen

이전
이후
변경 사항이 없습니다

단계 라인

[* black] Lay the bottom part of the device upside down on a table.
[* red] Locate the four PH1 screw heads on the underside.
[* black] We used the bit driver and 150mm driver extension with a 4mm driver(from IFIXIT pro tech toolkit) attachmentPH1 screwdriver bit (from [product|IF145-299|64 Bit Driver Kit]) to elongate the driver. Then, attached the PH1 driver head to the 4mm driver. (See note below and second image)
[* black] We used the bit driver and 150mm driver extension with a 4mm driver(from IFIXIT pro tech toolkit) attachmentPH1 screwdriver bit (from [product|IF145-299|64 Bit Driver Kit]) to elongate the driver. Then, attached the PH1 driver head to the 4mm driver. (See note below and second image)
[* icon_note] '''NOTE''': The PH1 screw heads are located 5cm into the device. Make sure to use a PH1 Driver that is at most 1cm in diameter and at least 5cm in depth.

이미지 2

이전 버전

새로운 버전

이미지 3

삭제됨