Skip to main content

#2 단계의 변경 사항

Jeff Suovanen- 에 의해 수정

편집 승인됨 에 의해 Jeff Suovanen

삭제되었습니다
추가
변경 사항이 없습니다

스텝 라인

[* icon_caution] Be careful when pullingblack] Heat the glass screen offperimeter of the phone because there is a connector which connectsdisplay using an iOpener, hair dryer, or heat gun.
[* icon_note] Heat will help soften
the screenadhesive securing the display, making it easier to the phone. This connector willseparate. The display should be removed separately in the next step.
[* icon_note] It may be necessary
heated until it's slightly too hot to heat the glass paneltouch, for roughly two minutes. Use extra caution if working with a heat gun or hair dryer to softengun, as applying too much heat will permanently damage the adhesiveOLED panel.
[* black] Carefully pryUse a suction cup to lift one edge of the screen just slightly, creating a small gap between the front display assembly offand the phone by sliding a plasticframe of the phone.
[* black] Insert an
opening toolpick into the gap.
[* black] Carefully slide the opening pick
around the seamperimeter of the device.
[*
phone to separate the adhesive.
[* icon_caution] If you plan to re-use the display, don't insert the opening pick more than a few millimeters into the phone, or you may damage the OLED panel underneath the glass.
[*
icon_note] UseYou may need to slide the suction cuppick around the perimeter multiple times to pullfully separate the screen off if it will notadhesive. Work slowly and carefully until the display begins to come off withfree.
[* black] Gently lift
the opening tooldisplay, but don't try to fully detach it yet—it is still connected by a ribbon cable lying underneath.
[* icon_caution] Be careful when pullingblack] Heat the glass screen offperimeter of the phone because there is a connector which connectsdisplay using an iOpener, hair dryer, or heat gun.
[* icon_note] Heat will help soften
the screenadhesive securing the display, making it easier to the phone. This connector willseparate. The display should be removed separately in the next step.
[* icon_note] It may be necessary
heated until it's slightly too hot to heat the glass paneltouch, for roughly two minutes. Use extra caution if working with a heat gun or hair dryer to softengun, as applying too much heat will permanently damage the adhesiveOLED panel.
[* black] Carefully pryUse a suction cup to lift one edge of the screen just slightly, creating a small gap between the front display assembly offand the phone by sliding a plasticframe of the phone.
[* black] Insert an
opening toolpick into the gap.
[* black] Carefully slide the opening pick
around the seamperimeter of the device.
[*
phone to separate the adhesive.
[* icon_caution] If you plan to re-use the display, don't insert the opening pick more than a few millimeters into the phone, or you may damage the OLED panel underneath the glass.
[*
icon_note] UseYou may need to slide the suction cuppick around the perimeter multiple times to pullfully separate the screen off if it will notadhesive. Work slowly and carefully until the display begins to come off withfree.
[* black] Gently lift
the opening tooldisplay, but don't try to fully detach it yet—it is still connected by a ribbon cable lying underneath.

이미지 1

이전 버전

새로운 버전

이미지 2

이전 버전

새로운 버전

이미지 3

이전 이미지가 없습니다

추가